Matrix E1X - Page 40

36
FIGURE E
FIGURE F
6) Remove the screw holding the ECB wire harness in place (Figure E).
7) Remove the defective ECB (Figure F).
8)ReverseSteps1-7forinstallinganewECB.
9) Tighten the eye bolts on the ECB mounting bracket so that the ECB belt is tensioned to 60 ft. / lbs for a used belt and 75 ft. / lbs for a new
belt.
10) Test the elliptical trainer for function as outline in Section 7.21.
7.10 ECB (ELECTRONIC BRAKE) REPLACEMENT - CONTINUED
CHAPTER 7: PART REPLACEMENT GUIDE