Matrix E1X - Console Keypad; Overlay Replacement

30
CHAPTER 7: PART REPLACEMENT GUIDE
7.6 CONSOLE KEYPAD / OVERLAY REPLACEMENT
1) Remove the console as outlined in Section 7.2.
2) Remove the 6 screws holding the console back to the front (Figure A). NOTE:Ifjustreplacinganoverlay,onlycompleteSteps4,8,&9.
3) Remove the wire connections holding the console back to the front (Figure B).
4) Disconnect the console back from the front (Figure C).
5) Using a razor blade, carefully peel up one corner of the overlay and then remove the whole overlay (Figure D). Remove any access
adhesive from the plastic.
FIGURE A
FIGURE B
FIGURE C
FIGURE D