Matrix E1X - ECB Replacement

35
7.10 ECB (ELECTRONIC BRAKE) REPLACEMENT
CHAPTER 7: PART REPLACEMENT GUIDE
1) Remove the front shrouds as outlined in Section 7.1.
2) Disconnect the ECB wire harness (Figure A).
3) Remove the 2 nuts holding the ECB to the ECB mounting bracket (Figure B).
4) Disconnect the 2 tension eye bolts from the ECB mounting bracket (Figure C).
5)Removethe4screwsholdingdowntheECB(FigureD).WhenreinstallingtheECBframe,torquethescrewsto12N-m.
FIGURE A
FIGURE B
FIGURE C
FIGURE D