52
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) Without hitting start or entering any program modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving, listen for any odd noises or squeaks.
2) After stopping movement, press the QUICK START button and begin using the machine.
3) Grasp the hand grips to check for proper heart rate response.
4) Press the level up and down buttons both on the hand grips and on the console to make sure resistance is fully functional.
5) If everything functions properly, stop pedaling and the unit will reset to normal operation after 30 seconds.
7.21 TESTING THE ELLIPTICAL TRAINER
CHAPTER 7: PART REPLACEMENT GUIDE
To Next Page
Loading...
