Matrix E1X - Page 43

39
7.12 DRIVE AXLE SET REPLACEMENT - CONTINUED
CHAPTER 7: PART REPLACEMENT GUIDE
FIGURE E
FIGURE F
FIGURE G FIGURE H
6) Remove the screw / nut holding the crank to the drive axle set (Figure E), and remove the crank (Figure F).
7) Remove the large nut holding the drive axle set to the frame (Figure G).
8) Use a hammer to push the drive axle to the right side and out of the frame (Figure H). NOTE: A piece of wood or other material should be
used between the drive axle set and the hammer to prevent damage to the drive axle threads.
9) Test the elliptical trainer for function as outlined in Section 7.21.