Matrix E1X - Page 49

45
7.16 LINK ARM REPLACEMENT - CONTINUED
CHAPTER 7: PART REPLACEMENT GUIDE
FIGURE E FIGURE F
FIGURE G FIGURE H
4) Remove the 3 screws holding the pedal assembly to the pedal arm (Figure E). Remove the hardware and 3 hole plate.
5) Slide the link arm assembly off of the pedal arm (Figure F). NOTE: Make sure to notice the order of the washers for reinstallation (wavy,
Teflon, pedal assembly, Teflon, 3 hole plate, screws).
6) Peel up the pedal foot pad, and remove the 4 screws holding the pedal to the link arm (Figures G & H).
7)ReverseSteps1-6toinstallanewlinkarm.
8) Test the elliptical trainer for function as outlined in Section 7.21.