Matrix SATATYA Devices Manual 263
DHCP Server Settings in Device Client
• Select the Enable DHCP Server check box.
• Select the desired Ethernet Port — LAN 1, LAN 2— which will be used for dynamic assignment of IP
Addresses to the DHCP clients (IP cameras).
LAN1 and LAN2, will be displayed if the NVRX installed supports two ports.
In LAN 1 Settings if the IP Assignment Mode is set as DHCP or PPPoE, then LAN 1 will be disabled. Refer
to “LAN 1”.
• Enter the Start IP Address. It is the starting IP Address to be assigned to the DHCP clients. The DHCP
Server will start assigning IP Addresses to the DHCP Clients from this IP Address onwards.
• Enter the Number of Hosts (that is the number of clients) to be assigned IP Addresses by the DHCP
Server.
• Enter the Subnet Mask to be assigned to the DHCP clients.
• Enter the DNS Address to be assigned to the DHCP clients.
• Enter the Lease Hours. This is the maximum time for which the IP Address will be allocated to the DHCP
client. Valid Range: 1 to 192 hours. DHCP clients should renew their lease within the Lease Hours. If the
clients do not renew their lease before the expiry of the configured Lease Hours, the server will free the IP
Address and this IP Address may be assigned to another DHCP client in LAN.
• Click Save.
Scan for
Device MAC Address
Scan to
Download
SATATYA SIGHT
To Next Page
Loading...
Need help?
General
