Matrix SATATYA Devices Manual 35
Do's and Don'ts:
The Matrix device is intended for indoor use only. Equipment must thus be installed into a controlled, dry, clean and
secure environment where temperature and humidity are within product specifications.
Please read the below instructions cautiously before installing SATATYA device to avoid potential problems or
dangers.
• Use the power cord which is supplied along with the equipment. Ensure adequate earthing at the
installation site.
• Do not dismantle the equipment.
• The SATATYA device can be either mounted on a table, wall or a rack for allowing clear visibility of displays
and easy access to operating controls.
• Do not touch the product with wet hands.
• Do not locate the SATATYA devices where there are high levels of vibration or shock.
• Equipment must be installed by a trained professional.
• Prevent metallic, foreign or liquid substances from getting inside the product. This includes insecticide or
flammable cleaning spray.
• There should be no obstruction on the side walls of HVR. On one side wall there is a FAN and opposite to
FAN side wall there are vent holes for air inlet.
To prevent the processor get damaged due to overheating, please read the below instructions:
• There should be at least some space i.e., 3-4 inches around the system for air circulation.
• In stack mounting condition, there should be minimum 1-2 inches air gap between two systems (bottom
and top).
• Make sure the ambient temperature for the systems is below operating temperature of the system (40
degree centigrade) day and night.
• Installation of the system should be away from heat sources and direct sunlight and dust free environment.
To Next Page
Loading...
Need help?
General
