36 Matrix SATATYA Devices Manual
Safety Instructions
NEVER INSTALL THE EQUIPMENT DURING A LIGHTENING STORM!
The Installer should always take basic safety instructions to reduce the risk of fire, electric shock and injury to
personnel and system. The following points need to be taken into account:
1. The SATATYA device should be installed and used within a pollution free environment and at a safe and
secure indoor location.
2. The equipment is to be installed by authorized Service Persons only. The SATATYA device comes installed
in a metallic cabinet.
3. Do not place the product at a location from where it can fall and cause damage to the product.
4. Install the SATATYA device away from Electromagnetic Inducing (EMI) equipment, such as electrical
generators, motors, and high voltage cables.
5. The product should be operated with appropriate power voltage supply as mentioned in the specification
sheet.
6. The system needs to have a clean and uninhibited air flow round the equipment as air is circulated
throughout the unit.
7. Ensure that appropriate ambient temperature is maintained. Excessive internal temperature can harm the
system.
8. Make sure the site's electrical system is properly grounded.
9. Ensure appropriate mains filtering and UPS are used in areas where the power source is susceptible.
Damage through power source fluctuations, spikes, etc. is not covered by warranty.
10. Install the SATATYA device in a stable and level location.
11. There are no serviceable parts within the equipment. For any issues or queries regarding the
equipment please contact your installer.
12. Unplug this unit during lightning storms or when unused for long periods of time.
DISCONNECT POWER BEFORE SERVICING.
Do not cut off the power or move the unit when hard drives are operating. Doing so may cause damage
and loss of data.
To Next Page
Loading...
Need help?
General
