108 Matrix SETU ATA211 V1 System Manual
• If the flag is set as 'No' the ATA will not send the REGISTER message to Registrar proxy or Outbound
proxy as applicable when SIP Account is enabled and configured with relevant information. ATA will start
sending NAT Keep Alive message (if applicable) only when call is initiated.
• When 'Send REGISTER?' flag is set to 'No' for Proxy SIP account, SIP account will be considered as
'Active' (or registered). In this case, the 'Status' page of Web Jeeves will display the registration status as
'Active' for the relevant SIP account.
• For proxy SIP Account where 'Send REGISTER?' is set to 'Yes', if 'SIP Over TCP' is disabled in 'WAN Port'
but 'Transport Configuration' on corresponding SIP Account is set to either 'TCP' or 'TCP (fallback to UDP),
SIP account will be considered as Failed. For such case, the 'Status' page of Web Jeeves will display the
registration status as 'Failed' and OG/ IC calls will not be allowed by ATA. Also, 'Reason for registration
failure' will be displayed as 'TCP Disabled'. Refer chapter 'Checking the Status' for details about status
parameters.
• The Yes or No flag will not affect processing the incoming calls by ATA.
Default = Yes.
Allow Outgoing Calls Without Registration?
• This feature allows ATA to make OG calls even when SIP Account is not registered. To achieve this, the
flag is provided as 'Yes' or 'No' for 'Allow Outgoing Calls Without Registration?'. The feature is applicable
only if flag for 'Send Register?' is set as 'Yes'.
• If the flag is set as 'Yes', the ATA will allow making OG calls even if the relevant SIP account is not
registered.
• If the flag is set as 'No', the ATA will not allow making an OG calls even if the relevant SIP account is not
registered. This flag will not affect processing of the incoming calls by ATA.
Default = No.
Re-Registration Timer
• This timer signifies the time after which the ATA will send Registration request again to get registered
• Range = 00001 to 65535 seconds.
Default = 3600 seconds.
Registration Retry Timer
• After sending the REGISTER request, if registration attempt fails, the ATA will again send the registration
request after the expiry of Registration Retry Timer. This registration retry timer increases by 1x, 2x …5x,
where 'x' is time for first retry.
• Range = 00001 to 65535 seconds.
Default = 10 seconds.
Authentication User-Id
• This is the Authentication Id for authentication of the SIP account. Max. 40 characters can be
programmed. The ASCII characters are allowed. This is relevant when SIP User ID and Authentication
User ID are not same.
Default = Blank.
To Next Page
Loading...
Need help?
General
