82 Matrix SETU ATA211 V1 System Manual
FXS Port Number
• In case of peer to peer calls, this number will be displayed on the SLT of the called party if the SIP ID is
programmed as '*' and instrument of the called party is compatible to display the number.
• FXS port number is also used as the 'port' on which the incoming call on FXO can be routed.
• It can be programmed using maximum 4 characters. The digits 0-9 and '*' are allowed.
Default = Blank.
Outgoing Calls
Allow OG Calls?
Select the option from Yes/No. Select 'No' if OG call is not to be allowed from ATA. Default = Yes.
OG Call Route
Select the SIP Account number or FXO from where you want to route the outgoing call when you make the OG
calls from FXS port. Following option can be selected:
• SIP Account1: If 'SIP Account1' is selected, all outgoing calls will be made using SIP Account1.
• SIP Account2: If 'SIP Account2' is selected, all outgoing calls will be made using SIP Account2.
• SIP Account3: If 'SIP Account3' is selected, all outgoing calls will be made using SIP Account3.
• FXO: If 'FXO' is selected, all outgoing calls will be made using FXO Port.
• Dialed Number Based Routing: If this option is selected, all outgoing calls will be routed as per the entries
made in Dialed Number Based Table.
Default = SIP Account1 (SIP1).
Please refer chapter “Dialed Number Table” in Configuring SETU ATA211.
Refer chapter “Making Calls” in Using ATA211, to know how to make OG calls on the selected trunk.
Auto PSTN Fallback
• This feature allows the user to get the number dialed from the alternate route (FXO port) automatically,
when the number could not be dialed using the desired SIP account.
• Select 'Yes' if the OG call should be automatically routed from FXO port, if the call made on SIP account,
could not be routed from SIP due to some reason.
Default = 'No'. (Refer topic “Making call using Auto PSTN Fall Back” in section Call Features)
Class of Service
• You can enable/disable following features from Class Of Service (COS): Call Hold, call Waiting, Attended
Transfer, Conference, Call Forward, Call Toggle, Blind Transfer and Do Not Disturb (DND).
• The feature will not work if it is not allowed from COS. (Refer topics “Managing Calls” and “Call Features”
in chapter 'Using SETU ATA211' for more information about features and programming using phone)
Default = Enabled (all features mentioned above)
Calling Party Number Presentation (CLIP)
• 'Calling Party Number Presentation' feature enables the presentation of the number of the calling party on
the display of your phone connected to FXS port.
• ATA211 supports CLI types: None, DTMF, FSK- Bellcore and FSK-ITU (V.23). Select the type of CLI
supported by your phone instrument. Select 'None' if CLI display is not required to be displayed on the
phone.
Default = FSK-ITU (V23).
To Next Page
Loading...
Need help?
General
