Matrix SETU ATA211 V1 System Manual 133
User Password
• User is a person who actually uses the SETU ATA211. Logging in using User Password will allow you to
access limited parameters of ATA211.
• The system allows you to change or default the 'User Password'.
• The ATA will give alert to the user 'You are not authorized to access this setting' if the user will try to access
any parameter of Web Jeeves for which he is not authorized.
How to Program?
Open the Web Jeeves and click on 'User Password' link. (Both Admin and User can access this Webpage). The
Webpage will be as shown below:
You will be able to access only Webpages mentioned in chapter "Reinstate the Default Settings", when you have
logged in to Web Jeeves using User password:
Change the User Password using Jeeves:
You can change User Password by following the steps given below:
• In 'Old Password' field enter the current password; enter new password in 'New Password' field and retype
new password in 'Re-enter to Confirm' field.
• Password can be of maximum 4 digits. Only digits from 0 to 9 are allowed.
• Whenever Admin/User changes the User Password from Jeeves, the User/Admin will be logout from the
Jeeves as a confirmation that, the password has been changed.
Default User Password is 1234.
If you forget the new password, you will be required to default the password.
Default the User Password using Access Code:
It is possible to default User password using access code. It can be done by following the steps given below:
• Dial the access code '#***'.
• You will get dial tone after successful execution of this Access Code.
• This will default the User Password to factory set value.
Default the User Password using Jeeves:
• After login as 'User', if the user defaults the ATA1S using Webpage 'Reinstate the Default Settings', the
system will default the 'User' password. Refer chapter “Reinstate the Default Settings”.
Relevant Topic:
1. “Reinstate the Default Settings” 145
To Next Page
Loading...
Need help?
General
