Matrix SETU ATA211 V1 System Manual 79
How to program?
Open the Web Jeeves and click on 'Digest Authentication' link. (Only Admin can access this Webpage). The Web
page will be as shown below:
Program the parameters as explained below:
• You can program up to 100 entries in the Digest Authentication Table.
• User ID: Program 'User Id' of caller IP device which is to be allowed to make IC call on ATA211 on the SIP
Account. This can be programmed using maximum of 40 characters. The ASCII characters are allowed.
Default = Blank.
• User Password: Program the 'User Password' of caller IP device which is to be allowed to make IC call on
ATA211 on the SIP Account.
This can be programmed using maximum of 16 characters with ASCII characters. Default = Blank.
Relevant Topic:
1. “SIP Accounts” 104
To Next Page
Loading...
Need help?
General
