7
Matrox Monarch HD hardware
• RTSP mode If Monarch HD is set to stream in RTSP mode, the unit
delivers stream data once a client connects to Monarch HD using the RTSP
streaming protocol, and therefore does not require you to press the Stream
button. When a client connects to Monarch HD, the Stream LED flashes.
• RTMP mode If Monarch HD is set to stream in RTMP mode, press the
Stream button to begin streaming your input source to the stream destination
specified in the stream settings. Pressing the Stream button starts the stream
for that device only. If your Monarch HD is set to control multiple Monarch
HD devices, you must use the control buttons on the
Control page of the
Command Center to start and stop streaming multiple Monarch HD devices
on the network at the same time (see “Control streaming and recording for
multiple devices on the same network” on page 28). When streaming, the
Stream LED flashes. Press the Stream button again to stop streaming.
¦NoteThe Stream button activates when you release the button. If you want
to start/stop streaming and recording at the same time, press and hold the
Stream and Record buttons and then release them at the same time.
Record button
Press the Record button to start recording your input source to the media selected
in the record settings. The Record button is disabled when Monarch HD is set to
Stream-only operating mode. For information on specifying your record settings,
see “Specifying Recording settings” on page 35. Pressing the Record button
starts the recording for that device only. If your Monarch HD is set to control
multiple Monarch HD devices, use the control buttons on the
Control page of the
Command Center to start and stop recording multiple Monarch HD devices on
the network at the same time (see “Control streaming and recording for multiple
devices on the same network” on page 28). When recording, the Record LED
flashes. Press the Record button again to stop the recording. Unless a specific
record duration limit was set in the record settings, Monarch HD limits the
duration of each recording to four hours and 50 minutes. The recording will
automatically stop when the duration limit is reached.
¦NoteThe Record button activates when you release the button. If you want to
start/stop recording and streaming at the same time, press and hold the record and
Stream buttons and then release them at the same time.
USB ports 1 and 2
Use the USB ports to connect a USB 2.0 or 3.0 media device for recording the
source connected to the Monarch HD HDMI input. To select USB port 1 or 2 as
the recording destination, see “Specifying Recording settings” on page 35.
Please note the following about using USB devices:
• Monarch HD writes to all USB devices (including USB 3.0 devices) at USB
2.0 speeds.
To Next Page
Loading...
