43
Automatic configuration page
Setting the date and time manually
1 Select Manual.
2 Set the Time, and enter a Date in the format DD/MM/YYYY, or click to
select a date from the calendar.
3 Click Apply. You’ll be notified that Monarch HD will be rebooted in order
to apply the changes.
Setting the date and time automatically
Setting the date and time automatically requires a local or public NTP server
address. An Internet connection is required to use a public NTP server.
1 Select Automatic.
2 Enter a local or public NTP server address. The default NTP server address
is time.nrc.ca.
3 Select a Time zone from the list. The current date and time associated with
the selected NTP server and time zone are displayed next to
Current date
and time
.
4 Click Apply. You’ll be notified that Monarch HD will be rebooted in order
to apply the changes.
Automatic configuration page
The Automatic configuration page in the Command Center is where you can
export the current Monarch HD settings to an XML file (called the Monarch HD
configuration file), import settings from a previously-created configuration file,
or import settings from the same XML file hosted on a web page.
When you have a Monarch HD configuration file, you can copy it to a USB
device, connect the device to USB port 2, and then perform a factory reset to
automatically load the settings. For more information on performing a factory
reset, see “Network connection and IP address” on page 16.
The option to boot up Monarch HD with all settings loading automatically from a
USB device, or loading settings from a web page URL at device reboot, allows
you to deploy other Monarch devices without logging in to the Command Center.
To Next Page
Loading...
