28
Chapter 4, Using the Command Center
Control streaming and recording for a single
device
To control streaming and recording for a single Monarch HD device, you can use
the following two methods:
• Use the control buttons in the Command Center (see “Control buttons” on
page 26).
• Use the Stream and Record buttons on the Monarch HD device (see Chapter
2, “Matrox Monarch HD Hardware and Connections”).
Control streaming and recording for multiple
devices on the same network
Monarch HD allows you to start and stop the streaming and recording for up to
five devices on the network at the same time. Each device streams and records the
input source connected to its HDMI input based on its own stream and record
settings.
Start
stream
(RTMP)
and record
This button lets you start simultaneous streaming
and recording, and is available only when the
Monarch HD device is set to stream in RTMP mode.
Click this button to start streaming and recording
the input source connected to Monarch HD’s HDMI
input. If controlling multiple Monarch HD devices,
those devices will begin to stream and record their
input sources as well. To stop streaming and
recording, you can either stop streaming and
recording at the same time, or use the separate Stop
stream and Stop record buttons to stop each process
separately.
Stop
stream
(RTMP)
and record
Click this button to simultaneously stop streaming
and recording the input source connected to
Monarch HD’s HDMI input. If controlling multiple
Monarch HD devices, those devices will stop
streaming and recording their input sources as well.
Stream and
record
button
disabled
The stream and record button is disabled. This
button appears when Monarch HD is currently
either streaming or recording, or when Monarch HD
is set to Stream-only or Record-only operating
mode.
Button Function
To Next Page
Loading...
