35
Specifying Recording settings
Using the RTMP streaming protocol
1 Select RTMP.
2 Specify the destination Server URL and Stream name provided by your
CDN or server administrator. If your CDN provides a streaming
XML file, or
when using Wowza Streaming Engine Manager, you can load the streaming
XML file instead of entering the server URL and stream name. To do so,
click
Browse... to select the file, and then click Load. When loading a
streaming XML file, just the destination information (server URL and
stream name) from the streaming XML file will be loaded. If the streaming
XML file contains encoding information, those settings will not be loaded.
Clear the
Server URL field to remove the XML file. Clear the Stream
name
field to remove the loaded streaming XML file.
¡ Important Please note the following:
$ If the stream name, username, or password is included in the stream URL,
do not enter the information in the respective text boxes.
$ Streaming XML files are not the same as Monarch HD configuration
XML files.
3 If your Flash-based server or CDN uses the “ModuleRTMPAuthenticate”
method for RTMP authentication, a username and password is used for
authentication, however, username and password information is not included
as part of the stream URL or streaming XML file. In this case, you must
enter the stream
Username and Password in the text boxes provided.
4 Start streaming the Monarch HD input source to a CDN or media server as
detailed in “Control streaming and recording for a single device” and
“Control streaming and recording for multiple devices on the same
network”.
Specifying Recording settings
To access the record settings, open the Monarch HD Command Center (see
“Accessing the Command Center” on page 19), and then choose
Settings >
Record
.
¦NoteThe Recording settings cannot be modified when Monarch HD is set to
Stream-only mode (see “Monarch HD operating modes” on page 30).
To Next Page
Loading...
