Matrox Monarch HD - Generating a Configuration File; Automatically Importing Monarch Settings on Factory Reset

45
Automatic configuration page
1 Go to the Automatic configuration page of the Command Center.
2 In the Load settings from a web page URL field, type the URL address of
a page hosting the configuration parameters.
3 Click Load.
4 (Optional) Select Load settings at device reboot if you want to have your
Monarch HD automatically load the settings from the specified URL the
next time it boots up.
Your settings will now match those of the chosen configuration file.
¦NoteWith Load settings at device reboot selected, you only need to
reboot/reset your Monarch HD and it checks the specified URL for updated
settings.
Generating a configuration file
You can export your current settings as a Monarch HD configuration file, which
you can then save to your computer, to a USB device connected to your
computer, or to a network drive. You can then use the configuration file to
configure other Monarch devices.
¦NoteYou cannot save to a USB device connected to the Monarch HD.
1 Go to the Automatic configuration page of the Command Center.
2 Under Export current settings to a Monarch HD configuration file,
click
Generate file.
3 Select a save location. Do not change the filename (MonarchSettings.xml) if
you plan to automatically configure a Monarch from a USB device (see
“Automatically importing Monarch settings on factory reset” on page 45).
The Monarch HD configuration file is created, and contains all the Monarch
settings as XML parameters.
Automatically importing Monarch settings on
factory reset
On factory reset, the Monarch HD can automatically import configuration
settings from a Monarch HD configuration file that is on a USB device connected
to the Monarch’s USB port 2.
1 Copy the Monarch HD configuration file to a USB device (see “Generating a
configuration file” on page 45).
¦NoteThe configuration file must have the original filename, given by the
Monarch HD when the file was generated (MonarchSettings.xml).
2 Connect the USB device to the Monarch HD's USB port 2 (see “USB ports 1
and 2” on page 7).