26
Chapter 4, Using the Command Center
Disabling Stream and Record buttons on the
Monarch HD device
You can disable the physical Stream and Record buttons on the Monarch HD
device to prevent someone from inadvertently stopping a streaming or recording
session. This option only applies to the Monarch HD you are connected to, and
not other Monarch HD devices you may be controlling.
°To disable the Stream and Record buttons:
1 In the Command Center, click Control.
For more information, see “Accessing the Command Center” on page 19.
2 Select Disable Stream and Record buttons on this Monarch HD
device
.
The Stream and Record buttons on the Monarch HD device are disabled.
¦NoteThis button disable feature is off by default and, when required, would
also need to be performed after a factory reset.
Enabling multi-device control
This section details how to enable multi-device control of up to four other devices
in the Command Center (see “Control streaming and recording for multiple
devices on the same network” on page 28).
1 In the Command Center, click Control.
2 Select Control multiple Monarch HD devices.
3 For each Monarch HD device that you want to control, enter the network IP
address
of the device. Click Scan after entering the IP address to verify if
the device can be found on the network. For information on acquiring a
Monarch HD’s IP address, see “Network connection and IP address” on
page 16.
4 Activate or deactivate the control for a Monarch HD device by selecting or
clearing the device’s
Active box.
Control buttons
The following table details the different states of the control buttons in the
Command Center.
¦NoteDepending on the selected operating mode (see “Monarch HD operating
modes” on page 30), stream or record functionality may not be available.
To Next Page
Loading...
