103
Safety and Security
Driving safety systems
The SBC brake servo assistance switches
off automatically:
approximately two minutes after you
turned the SmartKey in the starter
switch to position 0 or removed the
SmartKey
approximately two minutes after you
pressed the KEYLESS-GO** start/stop
button ( page 55) to turn off the en-
gine or power supply and opened the
driver’s door (with driver’s door
open, the starter switch is set to
position 0, same as SmartKey re-
moved from starter switch)
approximately 20 seconds after you
locked the vehicle from outside.
Note on driving with the SBC
Following extended periods of only
minor loads to your brake system,
you should occasionally apply the
brakes when traveling at high speeds.
This improves the grip of the brake
pads.
After driving on wet or snow-covered
roads, you should apply your brakes
firmly before parking your vehicle.
This produces heat which serves to
dry the brake disks and help prevent
corrosion.
On long and steep grades, shift to a
lower gear (gear range 1, 2 or 3) to
prevent the brakes from overheating
and to reduce brake wear.
After hard braking, it is advisable to
drive on for some time so that the air
stream will cool down the brakes
faster.
Only components approved by us for
use on Maybach vehicles (e.g. brake
pads) should be installed on your ve-
hicle. Brake pads not approved by us
for use on Maybach vehicles may im-
pair the safety of your vehicle.
Warning! G
Be very careful not to endanger other road
users when you apply the brakes.
To Next Page
Loading...
