MAYBACH 57 - Memory Function

140
Controls in detail
Memory function
You can store up to five different set-
tings for each SmartKey or SmartKey
with KEYLESS-GO**.
The following settings are saved for each
stored position:
 Seat and seat backrest position
 Settings for multicontour seat
The following additional settings can be
saved in the driver’s seat:
 Steering wheel position
 Interior rear view mirror position
 Exterior rear view mirror position
 Automatic climate control
In the driver’s seat, you can program key-
dependent memory settings. You can
store up to five different settings per
SmartKey or SmartKey with
KEYLESS-GO**.
The key-dependent memory functions as
soon as you:
 insert the SmartKey into the starter
switch
or in vehicles with KEYLESS-GO**
 press the start/stop button
(
 page 55) on the gear selector le-
ver.
These key-dependent memory settings
can be deactivated if desired. For more
information, see "Setting key
dependency" (
 page 182).
!
Prior to operating the vehicle, the
driver should check and adjust the
seat height, seat position fore and
aft, and seat backrest angle if neces-
sary, to ensure adequate control,
reach and comfort. The head re-
straint should also be adjusted for
proper height. See also the section on
airbags (
 page 79) for proper seat
positioning.
In addition, adjust the steering wheel
to ensure adequate control, reach,
operation and comfort. Both the in-
side and outside rear view mirrors
should be adjusted for adequate rear
vision.
Fasten seat belts. Infants and small
children should be seated in a proper-
ly secured restraint system that com-
plies with U.S. Federal Motor Vehicle
Safety Standard 213 and 225 and
Canadian Motor Vehicle Safety Stan-
dard 213 and 210.2.