229
Controls in detail
Power tilt/sliding sunroof
Fully raising and lowering the power tilt/
sliding sunroof
Open the screen if it is closed.
To raise or lower the tilt/sliding sun-
roof, press sunroof switch 6 past the
resistance point at 1 or 5 and re-
lease.
To stop the procedure, press the
switch again.
The tilt/sliding sunroof must be synchro-
nized
after the consumer battery has been
disconnected
the tilt/sliding sunroof has been
closed manually
a malfunction
the tilt/sliding sunroof does not open
smoothly
Remove the respective fuse from the
fuse box (
page 451).
Reinsert the fuse in the main fuse
box.
Switch on ignition ( page 54).
If the tilt/sliding sunroof is raised at
the rear, lower and close it.
Move and hold the sunroof switch in
direction of arrow 4 (
page 226) or
press sunroof switch 6 at 5
( page 227) until the tilt/sliding sun-
roof is fully raised at the rear.
Keep pressing the respective switch
for approximately one second.
Check the Express-open feature
(
page 227).
If the tilt/sliding sunroof opens com-
pletely, the roof is synchronized. Oth-
erwise repeat the above steps.
i
Vehicles with rear center seat*:
For operation with the Pocket PC re-
mote control* ( page 332).
Synchronizing the power tilt/sliding
sunroof (Maybach 62)
To Next Page
Loading...
