MAYBACH 57 - License Plate Lamp

433
Practical hints
Replacing bulbs
Turn signal bulb
 Switch off the lights.
 Turn the round cover in the wheel
housing trim counter-clockwise and
remove cover.
 Twist bulb socket 2 counterclock-
wise and pull out.
 Push bulb into socket, turn counter-
clockwise and remove.
 Insert new bulb in socket, push in and
twist clockwise.
 Reinsert bulb socket 2 in lamp and
twist clockwise.
 Replace round cover in wheel hous-
ing trim and turn it clockwise.
Parking and standing lamp bulb
 Switch off the lights.
 Open the hood ( page 355).
 Twist housing cover 1 counterclock-
wise and pull out.
 Pull out bulb socket 6 with the bulb.
 Pull the bulb out of the bulb
socket 6.
 Insert a new bulb in the socket.
 Reinstall bulb socket 6.
 Align housing cover 1 and twist
clockwise.
Side marker lamp bulb
 Switch off the lights.
 Turn the round cover in the wheel
housing trim counter-clockwise and
remove cover.
 Twist bulb socket 3 counterclock-
wise and pull out.
 Push bulb into socket, turn counter-
clockwise and remove.
 Insert new bulb in socket, push in and
twist clockwise.
 Reinsert bulb socket 3 in lamp and
twist clockwise.
 Replace round cover in wheel hous-
ing trim and turn it clockwise.
1 Screws
2 License plate lamp
 Switch off the lights.
 Loosen both screws 1 and remove li-
cense plate lamp 2.
 Replace the tubular lamp and rein-
stall lamp.
 Tighten the screws 1.
License plate lamp