438
Practical hints
Flat tire
The tube openings are located directly
behind the front wheel housings and in
front of the rear wheel housings.
3 Jack
4 Jack support tube hole
5 Ratchet
Insert jack 3 fully into tube hole 4
up to the stop.
Take ratchet 5 out of vehicle tool
kit.
Place ratchet 5 on jack 3 so that
you can see the letters UP.
Crank ratchet 5 up and down until
the tire is a maximum of 1.2 in (3 cm)
off the ground.
Removing the wheel
6 Alignment bolt
Unscrew uppermost wheel bolt and
remove.
Replace this wheel bolt with align-
ment bolt 6 supplied in the tool kit.
Remove the remaining bolts.
Remove the wheel.
Warning! G
Insert the jack arm fully into the jack sup-
port tube hole up to the stop. Otherwise
the vehicle may fall from the jack and
cause personal injury or damage to the ve-
hicle.
Warning! G
The jack is intended only for lifting the ve-
hicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
Never start the engine when the vehi-
cle is raised.
Never lie down under the raised vehi-
cle.
!
Do not place wheel bolts in sand or
dirt. This could result in damage to
the bolt and wheel hub threads.
To Next Page
Loading...
