64
Getting started
Driving
1 Seat belt outlet
2 Latch plate
3 Buckle
4 Release button
Pull the seat belt smoothly from the
seat belt outlet 1.
Place the shoulder portion of the belt
across the top of your shoulder and
the lap portion across your hips.
Push latch plate 2 into buckle 3 un-
til it clicks.
If necessary, tighten the lap portion
to a snug fit by pulling shoulder por-
tion up.
Proper use of seat belts:
Do not twist the belt when fastening.
Adjust seat belt so that the shoulder
portion is located as close as possible
to the middle of the shoulder (it
should not touch the neck or pass un-
der the arm).
Position the lap belt as low as possi-
ble on your hips (over hip joint) and
not across the abdomen.
Place the seat backrest in a nearly up-
right position.
Never use a seat belt for more than
one person at a time.
Warning! G
Never ride in a moving vehicle with the
seat backrest in an excessively reclined po-
sition as this can be dangerous. You could
slide under the seat belt in a collision. If
you slide under it, the belt would apply
force at the abdomen or neck. That could
cause serious or even fatal injuries. The
seat backrest and seat belt provide the
best restraint when the wearer is in a near-
ly upright position and the belt is properly
positioned on the body.
Only the reclining seat (in Maybach 62 rear
cabin) can be used in a reclined position
with seat belts properly fastened while the
vehicle is in motion. The reclining seat in
the Maybach 62 rear cabin includes a belt
system and kinematic electronic controls
that are designed to maintain proper sup-
port and restraint-system effectiveness in
all seat settings in the event of a collision
or similar situation.
Keep the door storage compartments
closed while the vehicle is in motion. Fail-
ure to do so may cause the seat belt to
catch at the rear and prevent proper posi-
tioning of the seat belt.
Warning! G
Read and observe the additional warning
notices printed in the "Safety and Securi-
ty" section
( page 82).
To Next Page
Loading...
