CAUTION
Do not shake the bottle excessively.
Otherwise, the sealant could spray
out of the injection hose, and if the
sealant contacts clothing or other
objects, you may not be able to
remove it.
NOTE
The sealant hardens easily and
injecting it will be difficult under
cold weather conditions (0 ℃
(32 ℉) or below). Warm the
sealant inside the vehicle to
facilitate injection.
7. Pull out the air compressor hose
and the air compressor plug from
the air compressor.
8. Install the air compressor hose
which was pulled out of the air
compressor to the injection valve of
the bottle.
CAUTION
Make sure that the air compressor
switch is off before inserting the air
compressor hose to the injection
valve of the bottle. If the air
compressor hose is not installed to
the injection valve of the bottle
securely, the sealant may leak.
9. Remove the valve cap from the
valve of the flat tire, install the
injection hose to the tire valve, turn
the sleeve to the right, and tighten
it.
10.Install the bottle to the air
compressor and press it in until the
left and right tabs are engaged
securely.
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-23
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34
To Next Page
Loading...
