11.Insert the air compressor plug into
the accessory socket inside the
vehicle and switch the vehicle
power to ACC (page 7-39).
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that
the air compressor switch is off.
When turning the air compressor
on/off,
use the air compressor
switch.
12.The sealant is injected into the tire
when the air compressor is
switched on. After the sealant is
injected completely, wait until the
tire inflation pressure increases to
the specified tire inflation pressure.
WARNING
Never use the air compressor
above 300 kPa (3.1 kgf/cm
2
, 3
bar, 43.5 psi).
Using the air compressor at an
inflation pressure above 300 kPa
(3.1 kgf/cm
2
, 3 bar, 43.5 psi)
continuously is dangerous. If the air
compressor overheats, hot air will
be exhausted and you could get
burned.
NOTE
The inflation pressure may
increase to about 300 kPa (3.1
kgf/cm
2
, 3 bar, 43.5 psi)
temporarily to inject the sealant
through the valve. Normally, the
inflation pressure decreases
gradually and it reaches the actual
inflation pressure after about 30
seconds.
Check the tire
inflation
pressure
label driver's door frame for the
correct tire inflation pressure.
Do not operate the air
compressor for a continuous 10
minutes or longer because using
it for long periods could cause a
malfunction.
If the tire inflation pressure does
not increase, repair of the tire is
not possible. If the tire does not
reach the specified tire inflation
pressure within 10 minutes, it
may have received extensive
damage. In this case, the repair
using the emergency flat tire
repair kit was not successful.
Contact an Authorized Mazda
Dealer.
13.Adhere the speed restriction sticker
in a place where it can be viewed
easily by the driver.
What to Do in Case of Emergency
Tire is Punctured or Bursts
8-24
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34
To Next Page
Loading...
