5. Detach the electrical connector
from the unit by pulling it to the
rear.
6. Install the new bulb in the reverse
order of the removal procedure.
Front side-marker lights
1. Make sure the vehicle power is
switched
off,
and the headlight
switch is off.
2. If you are changing the right bulb,
start the engine, turn the steering
wheel all the way to the right, and
turn
off
engine. If you are changing
the left bulb, turn the steering
wheel to the left.
3. Pull the center of each plastic
retainer and remove the retainers,
and then partially peel back the
mudguard.
1. Removal
2. Installation
4. Turn the socket and bulb assembly
counterclockwise and remove it.
5. Disconnect the bulb from the
socket.
6. Install the new bulb in the reverse
order of the removal procedure.
Rear side-marker lights
1. Make sure the vehicle power is
switched off, and the headlight
switch is
off.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the
socket.
4. Install the new bulb in the reverse
order of the removal procedure.
License plate lights
1. Make sure the vehicle power is
switched off, and the headlight
switch is off.
2. Wrap a flathead screwdriver with a
soft cloth to prevent damage to the
light unit.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-37
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34
To Next Page
Loading...
