3. Insert the screwdriver from the left
side (press in strongly) and move
the tip of the screwdriver
downward to remove the light unit.
4. Turn the socket and bulb assembly
counterclockwise and remove it,
then disconnect the bulb from the
socket.
5. Install the new bulb in the reverse
order of the removal procedure.
Replacing Interior Light Bulbs
Overhead light
1. Wrap a small flathead screwdriver
with a soft cloth to prevent damage
to the lens, and then remove the
lens by carefully prying on the edge
of the lens with the flathead
screwdriver.
2. Disconnect the bulb by pulling it
out.
3. Install the new bulb in the reverse
order of the removal procedure.
Trunk light
1. Wrap a small
flathead
screwdriver
with a soft cloth to prevent damage
to the lens, and then remove the
lens by carefully prying on the edge
of the lens with the flathead
screwdriver.
2. Disconnect the connector from the
unit.
Inspection and Servicing/Cleaning
Vehicle Exterior Inspection
9-38
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34
To Next Page
Loading...
