McCulloch Mini-Mac 6 User Manual

2. Hold saw with muffler side down.
3. Hold
throttle trigger full back and pull starter handle until eng ine starts.
BREAKING IN A NEW ENGINE
Run your saw engine at one-third throttle for three minutes and then at one-
half thr ottle for three minutes prior to making your first cut. By operating the
engine at part throttl e for the first few minutes with the correct fuel mixture,
all bearin g surfaces will be properly lubricated for lon ger life and better
performance.
The saw shruld always be operated at full throttl e when it is under load and in
the cut, but only when cutting under load conditions.
Make
several preliminary cuLs to get the feel of your saw. Stop the eng ine
after each preliminary cut and check the cha in to make SUre it is lubricated
prop er ly and to adjust chain tension.
12

McCulloch Mini-Mac 6 Specifications

General

Brand	McCulloch
Model	Mini-Mac 6
Category	Chainsaw
Language	English