McCulloch Mini-Mac 6 - Starting and Stopping Procedures; Standard Starting Steps

STARTING & STOPPING
1. Fill the fuel tank with the correct
fuel mixture . Fill the chain oil tank
with McCulloch Chain, Bar and
Sprocket Oil. Pump the manual
oiler lxItton until oil shows between
the chain and the bar at the top of
the bar where the chai n comes Qut
from b ehi nd the clu teh guard.
Figure 6.
2. Make sure the chain has the cor-
rect tension and that the bar is
tight on the saw.
3. Slide the ignition switch to th e ON position.
4. Turn the choke l ever to the fully closed pOSition. A warm engine usually
does not r e quir e the us e of the choke. However, when restarting an ex-
10