McCulloch Mini-Mac 6 User Manual

Check chain tension frequently on a new chain. Check chain tension at least
every hour on an older chain. If the chain is hot, allow it to cool before ad-
justing it. Correct chain tension results in easier cutting and operation.
Maintain it at all times.
NEW CHAIN BREAK-IN
1. Run the chain at slow speeds for at least three minutes. Make sure enough
oil is pumped onto the chain to flood the bar groove. Increase speed to half
throttle and run chain for another three minutes. Stop the engine and check
and adjust chain tension.
2. After using the saw for the first ten minutes, shut off the engine and again
check chain tension. Repeat tension check several times during the first
few hours of operation.
CHAIN LUBRICATION
Make sure the manual oiler works before starting your saw. Pump the oiler
button. Oil should appear between the chain and bar at the top of the bar just
forward of the sprocket guard. Keep the oil tank filled with clean oil.
29

McCulloch Mini-Mac 6 Specifications

General

Brand	McCulloch
Model	Mini-Mac 6
Category	Chainsaw
Language	English