McCulloch Mini-Mac 6 - Bar Maintenance; Bar Cleaning Procedure

Do not use the bar to pry objects. If the bar is pinched in wood and cannot be
freed, use wedges or an axe to force the wood apart and free the bar. Never
try to force wood apart with the bar.
CLEANING
After foor or five hours of operation,
remove the bar from the saw. Clean
the sawdust and grime from the oil
holes in the side of the bar and from
the passage between the oil holes and
bar groove. Use wire or pipe cleaner.
Clean all sawdust and grime from
sides of bar and bar mounting pad.
Reinstall bar with opposite edge
down to
equalize wear.
36
I
- :'~O:'~;'~~·
-- ~-
-----_/ ~
FIGURE 24 Bac Gmaves