McCulloch Mini-Mac 6 User Manual

2. start the engine and let it warm up for at l east three minutes. Do not race
the engine. If the engine will not idle and keeps stopping, turn the idl e speed
screw clockwise until the engine idles. The chain may move slowly when
the engine is cold. If it still moves after the engine is warmed up I turn the
screw counterclockwise until the chain stops.
3. Hold the eng in e bar nose down and turn the idle adjustment ne edle until the
engine idles smooth ly and accelerates without hesitation or stumbling . Final
position of the idle adjustment needl e will usually be between 1/ 2 and 3/ 4 of
a
turn open. Turn the engine to see that it idl es smoothly in all positions.
If necessary , readjust the idle speed screw to a point just below where the
chain starts to move.
4. While cutting wood with the saw, adjust the high speed adjustment needle for
best power. Do not judge by the sound; judge by the way the saw cuts. Final
position of the high speed adjustment needle should be 1/ 2 to 3/ 4 of a turn
open.
5.
Check idle operation again. It may be necessary to adjust the idle adjustment
needle slightly to obtain best idle operation after the high speed adjustment
ne edle has been set.
23

McCulloch Mini-Mac 6 Specifications

General

Brand	McCulloch
Model	Mini-Mac 6
Category	Chainsaw
Language	English