McHale C430/C460/C470/C490 Bale Chopper
44
After measuring carefully, the PTO shaft halves should be cut equally so that the PTO
shaft assembly is kept as long as possible, whilst just allowing enough room for its
removal. This will ensure that a maximum overlap (ideally 200 mm minimum) is
maintained, when extended.
Maximum 80° angle of movement should never be exceeded, otherwise permanent
damage will result.
(C460/C470/C490 only)
ATTENTION: PTO wide angle joint must never exceed 80 deg.
both during operation and when stationary, otherwise permanent
damage will result.
To Next Page
Loading...
