McHale Fusion Vario Baler & Wrapper
123
10.14.5 Brake maintenance
Drain condensation water from the air reservoir (air brake only)
Actuate the manual drain valve as necessary by pulling the ring, each day before
operating for a few seconds or until the water droplets disappear.
Ensure that the hand brake is engaged before carrying out this procedure.
4. Once the brake levers have been set, the
hand brake cables will need to be adjusted.
Set the threaded adjusters of both cables, at
the hand brake lever, so that most of the
available thread is towards the lever (as
shown). Ensure that the locknuts are
tightened securely against the serrated
washers after final adjustment.
5. Use the adjuster beside the wheel to
remove any slack from the cable. This must
be done for both wheels. Ensure that the
locknuts are tightened securely against the
serrated washers after final adjustment.
6. It should only be possible to pull the lever
about half way down the ratchet to activate
the brakes. If the lever can be pulled down
towards the bottom of the ratchet, then
adjust the cables at the wheels to ensure
the lever only pulls half way.
To Next Page
Loading...
