McHale Fusion Vario Baler & Wrapper
39
A good power supply is critical for proper machine operation as the electronic control
box is the main interface between the operator and the machine.
5.3 Attaching to drawbar
The drawbar is to be attached so that the machine is horizontal to the ground. (See
‘Drawbar adjustment’).
CAUTION: Electrical power supply
Do not use any other electric power supply for the electronic control
system, otherwise damage may occur.
Machines are set up for hitching to the tractor drawbar. Once the tractor is attached
to the drawbar, attach the PTO shaft. Depending on the country of use a safety chain
may also be required. Detach in reverse order of attachment.
CAUTION: Tractor drawbar and coupling device must be compatible
Check that the tractor drawbar is compatible with the coupling device
on the machine. If in doubt, consult your McHale dealer.
To Next Page
Loading...
