McHale Fusion Vario Baler & Wrapper
143
13.2 Start of season
Fully review this operators instruction manual.
Check and fill gearbox oil level, if necessary. (See ‘Gearbox oil’)
Lubricate all pivot points.
Tighten all bolts, nuts and setscrews. (See ‘Tightening torque values’)
Check air pressure of all tyres. (See ‘Tyre inflation pressures’)
Connect control box and inspect for correct operation of all functions. (See
‘Electronic control system’)
Inspect and modify, if necessary, all machine adjustments. (See ‘Field
operation & machine adjustments’)
Remove the grease from the net knife and cut and hold knives. Use extreme
caution when carrying out this operation, ensure to wear protective gloves and
clothing!
Check net wrapping adjustments and inspect net knife for sharpness, ensure
to wear protective clothing whenever working in this area! (See ‘Care of the
net wrapping system’). Follow instructions and carry out correct procedure.
Clean, adjust & lubricate both cut and hold slides. (See ‘Cut and hold system’)
Inspect aluminium dispenser rollers for a build up of tack/glue, clean off using
kerosene or diesel oil and wipe rollers dry.
Fill chain oil reservoir with chain oil & fit new grease cartridge, run PTO at
approx. 200 rpm and with the control box in manual mode, operate the bale tip
up and down for around 15 cycles to ensure that all chains have a new
coating of oil applied, and new grease in all bearings.
Pump grease into all grease points and centralised grease blocks to ensure
all bearings and joints are well lubricated.
To Next Page
Loading...
