McHale Fusion Vario Baler & Wrapper
98
2. Remove the linch pin and release the
dispenser film roll lock. Push down on
the spring-loaded dispenser roller
frame and engage the latch, to hold
the rollers away from the central pin.
3. Remove the old core and ensure it is
disposed of responsibly.
4. Push the new roll on the central pin,
engage the film roll lock and reinsert
the linch pin.
5. Thread the film through the dispenser
rollers, as per the threading diagram,
taking care not to trap fingers
between the rollers.
6. Pull approximately 1.5 m of film away
from the dispenser and make a knot
at the end of the plastic film. Push
down on the spring-loaded dispenser
roller frame and release the latch, to
allow the rollers back against the film
roll.
To Next Page
Loading...
