MCM Electronics iRIS8+ - Function 40 - Exit Time; Function 41 - Entry Time; Function 42 - Siren Time

Page 10
Options - (Single digit entry required)
0 - 0 seconds 5 - 50 seconds
1 - 10 seconds 6 - 60 seconds
2 - 20 seconds 7 - 70 seconds
3 - 30 seconds 8 - 80 seconds
4 - 40 seconds 9 - 90 seconds
Options - (Single digit entry required)
0 - 0 seconds 5 - 50 seconds
1 - 10 seconds 6 - 60 seconds
2 - 20 seconds 7 - 70 seconds
3 - 30 seconds 8 - 80 seconds
4 - 40 seconds 9 - 90 seconds
Options - (Single digit entry required)
0 - 0 seconds 5 - 2 min 40 sec
1 - 10 seconds 6 - 5 min
2 - 20 seconds 7 - 10 min
3 - 40 seconds 8 - 21 min
4 - 80 seconds 9 - 42 min
Description :
This function sets the time that sectors allo-
cated as entry/exit (Function 49), exit hando-
ver (Function 50) or partial exit/entry (Function
51) will allow for exit.
Description :
This function sets the time that sectors allo-
cated as entry/exit (Function 49), exit hando-
ver (Function 50) or partial exit/entry (Function
51) will allow for entry.
Notes :
Handover sectors will only have entry time if
an exit/entry sector has been triggered rst
Description :
This function sets the maximum time for which
the internal, external and satellite sirens and
bell output will operate.
Notes:
Australian Standards AS 2201 limit the sirens to be triggered only once per section unless manually re-armed.
Noise pollution regulations in limit siren time to 5 minutes.
Example : While in program mode (Program LED ashing)
Key Sequence Operation
40 - Enter Function No.
5 - Enter Option ( 5 = 50 seconds)
on - Store Entry
Installer may now exit program mode by pressing the OFF button or continue
programming by entering a new function number
Function 41 - Entry Time Default - 30 seconds
Example : While in program mode (Program LED ashing)
Key Sequence Operation
41 - Enter Function No.
3 - Enter Option (3 = 30 seconds)
on - Store Entry
Installer may now exit program mode by pressing the OFF button or continue programming.
Example : While in program mode (Program LED ashing)
Key Sequence Operation
42 - Enter Function No.
6 - Enter Option (6 = 5 minutes)
on - Store Entry
Installer may now exit program mode by pressing the OFF button or continue programming
Function 42 - Siren Time Default - 5 minutes
Function 40 - Exit Time Default - 60 seconds