MCM Electronics iRIS8+ - Enhancement and Versions

Page 32
iRIS 8 Enhancement and versions
IRIS8 Software Version
V7.82
- Added Option 4 in Function 87 – Enable GSM Fail Reporting, Single ash of FIRE
led equals GSM fail
- Added Option 8 in Function 80 – Enable GSM Fail Output
- Added Option 4 in Function 93 – Momentary Arm only for Full & Part Key switches
- Added Chime On/Off – Hold down 4 key to toggle chime on/off.
2 beeps for On / 3 beeps for Off
- Fixed Line Fail & Tamper report order when both event & restore are pending
- Increased inter-digit timeout from 3 sec to 5 sec when using User, Master or Tech codes
- Changed Cancel by User CID code to event not restore
V7.71
- Added “tamper in alarm” & “tamper isolated” to STATUS message.
- Added “tamper isolated” to isolate arm/partial SMS
- Added rmware version to STATUS message
- Changed Bell1 output to chirp using mini siren/strobe combo on disarm.
V7.70
- Added extra checking on GSM modem to ruggedise comms
- Recalibrated 24hr timer test
- Changed the word “Line” to “PSTN” in status SMS
- Improved GSM/SMS operation
- Fixed partial arming via SMS with an entry/exit open....
... sms response may show tamper unsealed, rather than zone 1 or 2 open.
V7.68
- Allowed arming while an entry/exit section is opened
V7.67
- Added Tamper Isolate via User Code
- Added Function 87
1 – Disable Tamper Input
2 – Tamper is Silent
3 – Tamper is active only when in On or Partial mode else if not selected tamper is 24hr
V7.66
- Fixed chime operation
- Improved line fail operation
- changes in RF/GSM programming to improve swapping between modules
- Updated RF key fob mapping
V7.54
- Allowed pauses in GSM phone number
- Removed arming chirps & strobe ashes on remote (keyswitch & RF module) for partial arming.
- Removed exit delay beeps for partial arming
V7.53
- Initial software release for IRIS8