MCM Electronics iRIS8+ - Phone Number Configuration; Function 64 - Phone Number 1; Function 65 - Phone Number 2; Function 66 - Phone Number 3 (SMS)

Page 14
Options : (Maximum of 15 digits)
Description :
Selects whether open / close reports are
sent or not.
Options : (Single digit entry required)
1 Open / Close sent
0 No Open / Close sent.
Function 63 - Open/Close reports - Yes / No. Default -Send open /close
Description :
The phone number may be up to 15 digits long
including pauses. Pauses (1 second) may be
entered anywhere by pressing the Partial key.
Example : While in programmode (Program LED ashing)
Key Sequence Operation
63 - Enter Function No.
0 - Enter Option (0 = no report )
On - Store Entry
Installer may now exit program mode by pressing the OFF button or
continue programming by entering a new function number.
This phone number is the rst number
used by the panel when reporting to the
monitoring company.
Options : (Maximum of 15 digits)Description :
Example : While in program mode (Program LED ashing)
Key Sequence Operation
64 - Enter Function No.
218572 - Enter Option (Phone number 1 is 218572)
On - Store Entry
Installer may now exit program mode by pressing the OFF button or continue
programming by entering a new function number.
Function 65 - Phone number 2 Default - None
Example : While in program mode (Program LED ashing)
Key Sequence Operation
65 - Enter Function No.
218067 - Enter Option (Phone number 2 is 218067)
On - Store Entry
Installer may now exit program mode by pressing the OFF button or continue
programming by entering a new function number.
The phone number may be up to 15 digits long
including pauses. Pauses
(1 second) may be entered anywhere by pressing
the Partial key.
This phone number is the alternative num-
ber used by the panel when reporting to the
monitoring company and is only used if the
panel fails to report to Phone #1
Function 64 - Phone number 1 Default - None
Function 66 - Phone number 3 (see also SMS mode - function 88) Default - None
Options : (Maximum of 15 digits)Description :
The phone number may be up to 15 digits long
including pauses. Pauses (1 second) may be
entered anywhere by pressing the Partial key.
Example : While in program mode (Program LED ashing)
Key Sequence Operation
66 - Enter Function No.
218067 - Enter Option (Phone number 2 is 218067)
On - Store Entry
Installer may now exit program mode by pressing the OFF button or continue
programming by entering a new function number.
This phone number is the alternative number
used by the panel when reporting via SMS
with the iGSM ..Version 8.02 + only