93808 – October 2014 Page 17
6092RT Operating Instructions
Base Controls Operation and Test
IMPORTANT—Be sure the area above the machine is clear of obstructions to allow full elevation of platform.
Select BASE Operation
• Turn the Selector Key Switch to BASE.
Emergency Stop
• Press the Emergency Stop Switch at any time to stop all machine functions.
•Turn switch clockwise to reset.
Do not elevate the platform if the machine is not on a firm level surface.
Elevate Platform
• Press and hold the RAISE button on the base control panel to elevate the platform.
Test Operation
• Elevate to maximum height.
Note: Platform will not elevate beyond 30 ft. (9.15 m) without the outriggers
deployed
• Releasing the button will stop elevation.
• Pressing the Emergency Stop Switch will stop elevation.
Lower Platform
• Press the LOWER button on the base control panel until the desired platform height
is reached.
Test Operation
• Lower the platform to the stowed position.
• Releasing the button will stop descent.
• Pressing the Emergency Stop Switch will stop descent.
ART_3035
ART_2506 R2
ART_3036
To Next Page
Loading...
