Mec 6092RT - Pre-Start Inspection

93808 – October 2014 Page 27
6092RT Machine Inspections and Maintenance
Pre-Start Inspection Checklist
The operator must conduct a thorough Pre-Start Inspection of the machine before each work shift.
General Inspection Checklist
Initial Description
BBBBBBB Check that the operator’s, safety, and responsibilities manuals are in the storage container located on the platform.
BBBBBBB Perform a visual inspection of all machine components. Look for missing parts, torn or loose hoses, hydraulic fluid
leaks, torn or disconnected wires, damaged tires etc.
BBBBBBB Check all structural components of the machine for cracked welds, corrosion and collision damage.
BBBBBBB Check the security and condition of the lanyard attachment points.
BBBBBBB Check all hoses and the cables for worn or chafed areas.
BBBBBBB Check the platform rails and sliding mid-rail entry for damage or modification.
BBBBBBB Check that all warning and instructional decals are legible and secure.
BBBBBBB Check the tires for damage.
BBBBBBB Check the lower limit switch for visual damage or loose or missing hardware.
BBBBBBB All structural components, pins and fasteners are present and properly tightened.
Fluid Level Checklist
BBBBBBB Check for fluid leaks.
BBBBBBB Hydraulic fluid level (check with platform fully lowered).
Secure for operation
BBBBBBB Secure all covers and panels.