93808 – October 2014 Page 37
6092RT Troubleshooting
Troubleshooting
Should you experience erratic operation or notice any malfunction while operating this machine,
discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do not use the machine until it has
been checked by a trained, qualified mechanic.
Machine functions will not operate
• Battery properly connected?
•Battery fully charged?
• Function toggle switch or the Enable Switch not activated?
• Selector Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Hydraulic fluid level low?
• Obvious fluid leak or damaged component?
• Wires disconnected, broken, or loose?
• Motor control processor Diagnostic LED OFF?
LED should be ON. If not N or FLASHING, refer to Service Manual or contact MEC
Technical Support.
ART_3093
GP400
Module
Diagnostic LED
Lower Controls
Terminal
Block
Module
To Next Page
Loading...
