93808 – October 2014 Page 1
6092RT Introduction
Introduction
This Operator’s Manual has been designed to provide you, the customer, with the instructions and operating procedures essential to
properly and safely operate your MEC Aerial Work Platform for its intended purpose of positioning personnel, along with their
necessary tools and materials, to overhead work locations.
The Operator’s Manual must be read and understood prior to operating your MEC Aerial Work
Platform. The user/operator should not accept operating responsibility until he/she has read and
understands the operator’s manual as well as having operated the MEC Aerial Work Platform under
supervision of an authorized, trained and qualified operator.
It is essential that the operator of the aerial work platform is not alone on the workplace during
operation.
Modifications of this machine from the original design and specifications without written permission
from MEC are strictly forbidden. A modification may compromise the safety of the machine, subjecting
operator(s) to serious injury or death.
Your MEC Aerial Work Platform has been designed, built, and tested to provide safe,
dependable service. Only authorized, trained and qualified personnel should be allowed to
operate or service the machine.
MEC, as manufacturer, has no direct control over machine application and operation. Proper
safety practices are the responsibility of the user and all operating personnel.
Use of this machine in Europe must comply with
CE standard EN280:2013 and applicable
government regulations. Use in Australia and New Zealand must comply with
Australian Standard
AS/NZS1418.10:2011.
Use only MEC-approved replacements parts in the repair and maintenance of this machine.
If there is a question on application and/or operation contact:
MEC Aerial Platform Sales Corp.
1401 South Madera Avenue
Kerman, CA 93630
USA
Phone: 1-877-632-5438
559-842-1500
Fax: 559-842-1520
www.mecAWP.com
To Next Page
Loading...
