Page 28 93808 – October 2014
6092RT Machine Inspections and Maintenance
Monthly Inspection Checklist
This checklist must be used at monthly intervals or every 100 hours of machine use, whichever occurs
first. Failure to do so could result in death or serious injury.
The frequency and extent of periodical examinations may depend on national regulations.
Scheduled Maintenance Inspections should be conducted by qualified service technicians only. Photocopy this page for reuse. Keep
inspections records up to date. Record and report all discrepancies to your supervisor.
Model Number ________________ Serial Number ________________________ Hour Meter Reading ________________
Initial Description
BBBBBB Perform all checks listed on Prestart Inspection.
BBBBBB Inspect the condition of hydraulic fluid in the reservoir. Oil should have a clear amber color.
BBBBBB Check battery electrolyte level and connections.
BBBBBB Check wheel lug nuts for proper torque (see “Machine Specifications”).
BBBBBB Check if tires are leaning in or out.
BBBBBB Inspect all beams and pivot points for signs of wear and/or damage.
BBBBBB Check the pin joints and retaining rings for security.
BBBBBB Inspect the entire machine for signs of damage, broken welds, loose bolts, improper or makeshift repairs.
BBBBBB Check that the platform does not drift down with a full load.
BBBBBB Lubricate the axle float cylinder pivot mounts (see Lubrication Chart).
BBBBBB Check all wire connections.
BBBBBB Check that all adjustable flow valves are locked, check setting if any are not locked.
BBBBBB Check outriggers for proper operation (if equipped).
DATE________INSPECTED BY __________________________________________
To Next Page
Loading...
