Mec 6092RT - Drive, Steering, and Brake Operations

Page 20 93808 – October 2014
6092RT Operating Instructions
Steering
• Always check front steer wheel direction before driving.
• With the Mode Select Switch in the DRIVE position, squeeze the Enable Bar and press
the Steering Switch with your thumb to steer left or right.
Test Operation
• Releasing the Steering Switch will stop steering function.
• The steer wheels will not center themselves after a turn. The steer wheels must
be returned to the straight-ahead position with the Steering Switch.
Drive Speed
Drive speed is selectable until the platform is elevated above 10 Feet (3 m). When the platform
is elevated the machine defaults to HIGH TORQUE and the switch is locked-out (non
functioning).
• HIGH SPEED: allows speeds up to 4.4 m.p.h. (7.0 km/h).
• HIGH TORQUE: use to drive up or down a slope that is too steep for normal speed.
Drive Forward
• Place the Mode Select Switch in the DRIVE position.
• Squeeze the Enable Bar and move the Joystick away from you.
Test Operation
• Drive speed is proportional and is dependent on the movement of the
Joystick.
• Releasing the Enable Bar or returning the Joystick to the center position will
stop drive.
• Pressing the Emergency Stop Switch will stop drive.
Drive Reverse
• Place the Mode Select Switch in the DRIVE position.
• Squeeze the Enable Bar and move the Joystick toward you.
Test Operation
• Drive speed is proportional and is dependent on the movement of the
Joystick.
• Releasing the Enable Bar or returning the Joystick to the center position will
stop drive.
• Pressing the Emergency Stop Switch will stop drive.
Brake
• For parking, the brake is automatically applied when the Joystick is positioned in the
neutral (center) position.
ART_2362 R2
ART_3187 R1
ART_2362 R2
ART_2362 R2