Multitest 0.5d, 1d & 2.5d
Service and Repair Manual
Ensure that the stand is set as 9600 baud, send the command ‘gp’, the stand will
return its settings
Return this information to the Mecmesin Support Team to decipher.
29. Note regarding HyperTerminal/FUNterm:
When the system is correctly setup a '?' from HyperTerminal gives a response of
'load' 'displacement', e.g. 0.000,3.8632.
If the gauge is not connected to the MultiTest-d (or the gauge is not powered up) and
you send a '?', you will receive '?1' as the response.
To Next Page
Loading...
