page 39 of 73
system is on before you turn the spindle rotations on,
• homing procedure,
• setting the project's starting position,
• moving in any axis by a given distance to to absolute co-ordinates
The control window shows the machine co-ordinates (in relation to its absolute home position)
as well as the project's co-ordinates (in relation to its starting location). Note the remote control
display only shows the project's co-ordinates.
This window can display in the alternative, touch-friendly mode as described earlier (Control
Window - enlarged).
www.megaplot.com phone: +48 693 707 575 office@megaplot.com
To Next Page
Loading...
